Zebra 49834 Manual De Usuario
42
170PAX4 Maintenance Manual
57518L-001 Rev. A
3/18/05
Operations
Connect the Print Engine to a Power Source
Power Cord Specifications
Depending on how your print engine was ordered, a power cord may or may not be included.
If one is not included or if the one included is not suitable for your requirements, refer to the
following guidelines:
If one is not included or if the one included is not suitable for your requirements, refer to the
following guidelines:
•
The overall cord length must be less than 9.8 ft. (3.0 m).
•
The cord must be rated for at least 5 A, 250 V.
•
The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic
interference. The third wire in the power cord grounds the connection (
interference. The third wire in the power cord grounds the connection (
).
Figure 18 • Power Cord Specifications
•
The AC power plug and the IEC 320 connector must bear the certification mark of at least
one of the known international safety organizations shown in
one of the known international safety organizations shown in
Figure 19 • International Safety Organization Marks
1
AC power plug for your country
2
3-conductor HAR cable
3
IEC 320 connector
4
Contact view of plug—(a) neutral, (b) earth, (c) live
1
2
3
4
a
b
c
+
R