Nissan 4083 Manual De Usuario

Descargar
Página de 6
 
 
 
’98-’99 Frontier – Kit# 4083 
39. Double-check the vehicle. Check all mounting 
hardware to be sure that it is properly tightened. Check all 
wires, hoses, cables, etc. to be sure that there is ample 
slack. Check the vehicle electrical system. Start the 
vehicle. Check the steering in both directions to be sure 
that there is no bind. Check clutch operation. Check the 
operation of the brake system and the parking brake. 
Check both shift levers’ operation. Be sure that there is 
proper engagement in all gears and 4 wheel drive ranges. 
Check coolant level. Caution:  never open a closed 
cooling system after the vehicle has been started. Only fill 
the cooling system if the cap has been removed while the 
vehicle was still cold. Fill the coolant to the proper level. 
Reinstall the radiator cap. Carefully check all hoses to be 
certain that they have been connected properly and that 
there is ample slack. With the amount of hoses on this 
vehicle, it is vital that this be checked thoroughly. Test-
drive the vehicle in all gears and 4 wheel drive ranges. 
Pay very close attention to all vehicle systems. Check all 
hardware again in 500 miles and as part of your regular 
maintenance schedule. 
 
  CAUTION 
Performance Accessories does not recommend any 
particular wheel and tire combinations for use with its 
body lifts and can not assume responsibility for the 
customer’s choice of wheels and tires.  Your owner's 
manual can be referenced for recommended tire sizes 
and warnings related to the use of oversized tires.  Larger 
wheel and tire combinations increase stress and wear on 
steering and suspension components, which leads to 
increased maintenance and higher risk for component 
failure.  Larger wheel and tire combinations also alter 
speedometer calibration, braking effectiveness, center of 
gravity, and handling characteristics.  Consult with an 
experienced local off road shop to find what wheel and tire 
combinations work best with your vehicle. 
 
NOTE 
All warranty information, instruction sheets, and other 
documents regarding the installation of this product 
must be retained by the vehicle owner. Information 
contained in the instructions and on the warranty card 
will be required for any warranty claims. The vehicle 
owner needs to understand the modifications that have 
been made to his vehicle and how they affect the 
handling and performance of the vehicle. Failure to 
provide the customer with this information can result in 
damage to the vehicle and possible personal injury. 
 
 
 
 
 
Kit Parts List. 
Quantity Description 
3” x 3” blocks 
3” x 2” blocks 
3” Lower Radiator Support 
Bracket, Front - Right 
Bracket, Front - Left 
Outer Cab Support Plates 
Bracket, Power Steering Reservoir 
Bracket, Parking Brake 
Spacers, Bed W/ Holes 
Spacers, Bed W/O Holes 
Extension, Fuel Filler 
1 Extension, 
Shift 
Hose, Rubber ½” - 19” 
Hose, Rubber ¼” - 17” 
1 Instruction 
Sheet 
1 Loctite 
1 Logo 
Label 
1 Warning 
Label 
Bolt Pack 
Bolt, M10-1.25 x 180 (Fine Thread) 
Bolt, 7/16-14 x 7” 
Bolt, ½-13 x 4-1/2” 
Bolt, ½-13 x 5” 
Bolt, ½-13 x 5-1/2” 
Nut, Nylock ½-13 
Washer, ½ USS 
Washer, ½” Thick 
Nut, Nylock 7/16-14 
Washer, 3/8” USS 
Bolt, 3/8-24 x 1-1/4” 
1 Steering 
Extension 
Hardware Pack 
Bolt, M10-1.25 x 100 (Fine Thread) 
Bolt, ¼-20 x 1” 
Nut, Nylock ¼” 
10 
Washer, ¼” SAE 
Bolt, 5/16-18 x 1” 
Nut, Nylock 5/16-18 
Washers, 5/16 USS 
Bolt, 3/8-16 x 1” 
Nut, Nylock 3/8-16 
Washer, 3/8 USS 
16 
Bolt, 7/16-14 x 1” 
16 
Nut, Nylock 7/16-14 
24 
Washer, 7/16 USS 
Washer, 7/16 SAE 
Clamp, Hose #6 
Clamp, Hose #10 
Clamp, Hose #28 
Pin, Roll 1/8” x 1” 
Extension, 3” Shift Pin 
Hose, Vacuum Extension Tube 
Hose, Heater Extension Tube 
Hose, Extension, Fan Shroud/Heater 
 
Rev 03, Copyright 04/06 
Performance Automotive Group