National Instruments PCI-1200 Manual De Usuario

© National Instruments Corporation

This chapter describes how to install and configure your PCI-1200.

If you are using NI-DAQ, or National Instruments application software, 
refer to the installation instructions in your software documentation to 
install and configure your software.

If you are a register-level programmer, refer to the PCI-1200 Register-Level 
Programmer Manual.

The PCI-1200 can be installed in any unused PCI expansion slot in your 
computer.

The following are general installation instructions. Consult the user manual 
or technical reference manual for your computer for specific instructions 
and warnings.

1.

Turn off your computer.

2.

Remove the top cover or access port to the I/O channel.

3.

Remove the expansion slot cover on the back panel of the computer.

4.

Insert the PCI-1200 in an unused 5 V PCI slot. The fit may be tight, but 
do not force the board into place.

5.

Screw the PCI-1200 mounting bracket to the back panel rail of the 
computer or use the slot side tabs, if available, to secure the PCI-1200 
in place.

6.

Replace the top cover on the computer.

The PCI-1200 board is installed.