Konica Minolta micropress release 6 Manual De Usuario

An Advanced button may be displayed on this dialog depending on the type of device con-

nected to the PrintLink. Click Advanced to display a dialog with the following information:

Maintenance Counters

Counters are used to track the life of various components.

• Developer
• Drum  Unit
• Fuser
• Tray 1 Rollers
• Tray 2 Rollers
• Tray 3 Rollers
• Deck Rollers
• Life Counter
• Charge Counter 
• Total (Simplex Letter/A4 Equivalent) Page Count – the Charge Counter value multiplied by 

100

PrintStation ROM Revision

Version of the firmware in the PrintStation.

PrintStation ROM Level

Version of the firmware in the PrintStation.

PrintStation Adapter Flash 
Version

Part number and revision level of the upgradeable MicroPress PrintAdapter software.

PrintStation Adapter ROM 
Level

Part number and revision level of the MicroPress PrintAdapter boot code.

Engine Info

• Revision – Firmware revision in the device connected to the PrintLink
• Finisher Revision – Version information for the finisher
• Sleep after x minutes – Time period from the last printed page until the PrintStation/Print-

Link goes to “sleep” (low power mode). Printer automatically wakes when a new job 
arrives.

Set Paper Tray Size

Set for the type of paper in the input tray. Exception is the 2nd tray. This tray displays the 
tray setting.

Error Reset

Resets engine after error occurs

• Abnormally Low Temps - Error with the fuser unit causing fuser unit temperature to be too 

low. 

• Warm Up Abnormality - Error with fuser unit preventing fuser from reaching the ready 

temperature. 

• Abnormally High Temps - Fuser unit temperature too high. 

Note: Thermal protection devices will prevent the fuser from reaching extreme temperatures. 
Since these devices are similar to fuses, they will prevent the fuser from warming up again. 
The fuser may now indicate: “Abnormally Low Temps” following the “Abnormally High 
Temps” error if the machine has been turned off.

• Fan 1 - Fixing Unit/Scanner Unit Fan.
• Fan 2 - Power Supply Fan.
• Fan 3 - Electrical Unit Fan.
• Fan 4 - Fixing Unit Fan
• Main Motor - Abnormal main motor revolutions. See Main Motor below.

Registration guide in the duplex unit is not moving correctly.