Zanussi zwh7120 p Manual De Usuario
7
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs etc.
machine is not impeded by carpets, rugs etc.
Check that the machine does not touch the
wall or cupboard units.
wall or cupboard units.
This could be done by tying it to the tap with a
piece of string or attaching it to the wall.
piece of string or attaching it to the wall.
In a sink drain pipe branch.
This branch
must be above the trap so that the bend is
at least 60 cm above the ground.
at least 60 cm above the ground.
Directly into a drain pipe at a height
of not
less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter of
the drain hose.
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter of
the drain hose.
The drain hose must not be kinked. Run it along
the floor; only the part near the drainage point
must be raised.
the floor; only the part near the drainage point
must be raised.
In this case, make
sure the end cannot
come unhooked when
the machine is
emptying.
sure the end cannot
come unhooked when
the machine is
emptying.
Connect the water inlet hose to a tap with
3/4” BSP thread.
3/4” BSP thread.
Use the hose supplied with the washing
machine. DO NOT USE OLD HOSES.
machine. DO NOT USE OLD HOSES.
The other end of the inlet hose which
connects to the machine can be turned in
any direction.
connects to the machine can be turned in
any direction.
Simply loosen the fitting, rotate the hose and
retighten the fitting, making sure there are no
water leaks.
retighten the fitting, making sure there are no
water leaks.
Water inlet
Never place cardboard, wood or similar
materials under the machine to compensate
for any unevenness in the floor.
materials under the machine to compensate
for any unevenness in the floor.
Carefully level by
screwing the
adjustable front feet
in or out.
screwing the
adjustable front feet
in or out.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
The end of the drain hose can be positioned in
three ways:
three ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine.
plastic hose guide supplied with the
machine.
Water drainage
For the correct functioning of the machine
the drain hose must remain hooked on the
proper support piece situated on the top
part of back side of the appliance.
the drain hose must remain hooked on the
proper support piece situated on the top
part of back side of the appliance.
90 cm
60 cm