U-Line CLR2060 Manual De Usuario
12
User’s Manual
CONNECTING THE WATER SUPPLY
When connecting the water supply, follow these guidelines:
• Review the local plumbing codes before you install the unit.
• In most instances, the cold water supply will come from the
• In most instances, the cold water supply will come from the
basement through a hole in the floor.
• The water pressure should be between 20 and 120 psi.
If you are using a filter system you will need to have at least
20 psi for 3 minutes every 15 minutes.
20 psi for 3 minutes every 15 minutes.
• Install a SHUT-OFF VALVE in the 1/4" supply line (not
supplied with unit).
• Connect sufficient tubing to the unit to allow the unit to be
moved for cleaning and servicing. However, make certain that
the tubing is not pinched or damaged during installation.
the tubing is not pinched or damaged during installation.
• U-Line recommends the use of copper tubing for installation.
Figure 4
1. Locate the compression fitting and ferrule packed in the unit. Slide
the compression fitting and ferrule over the 1/4" water supply
line. Do not use thread sealing compound or tape. Using two
wrenches, tighten the compression fitting on the supply line (see
Figure 5).
line. Do not use thread sealing compound or tape. Using two
wrenches, tighten the compression fitting on the supply line (see
Figure 5).
UL103_CO
WATER
CONNECTION
CAUTION
Body_UM.qxd 12/17/04 9:16 AM Page 12