Microboards Technology hcl-4000 Manual De Usuario

• Operation 

 

HDD to CD Speed 
Adjusted to: 8x 

Microboards B.30 
8. Master Mode 

Microboards  B.30 
1. Copy       (SM) 

Microboards  B.30 
9. Erase RW 

Counter: 
No Counter 

Loader Processing 
Drive 1 <- Input Bin 

Processing ... 
Please Wait 

Once your selection has been changed successfully, you will see the 
display to the left for 2 seconds:  

You will automatically be returned to the Main Menu.  

The  Select Source menu is used to set the Master Reading Source. In the autoloader, the Master Reading 
Source is always the Hard Drive. 
 

The  Master Mode menu is used to select between Single Master mode or 
Multi Master mode. For more information on the modes, see Single Master 
and Multi Master Modes on page 11.  
 
Press the appropriate Quick Button to set the mode immediately.   

Alternately, you can use the   Up or   Down button at the Main Menu to 
find the 8. Master Mode  menu.  
 

Press the   OK button on 8. Master Mode to change the mode. 
 
Use the   Up or   Down button to choose between Single Master mode and Multi Master mode. Press the   
OK button to enter your selection. The system will return you back to the main menu. 
 

Use the Erase RW menu to erase your Rewritable discs.  

 
Use the   Up or   Down button to find the 9. Erase RW  menu.  
 
 
 
Press the   OK button on 9. Erase RW to enter the menu. 

 

There are two options: 

¾  Full Erase: This option erases the entire disc, destroying all previously written data in the process.  
¾  Quick Erase: This option erases the index (TOC) of the Rewritable disc, not the data section. It is 

much faster than Full Erase. However, the data section is still recoverable. In order to ensure all old 
content on the RW disc is completely erased and unable to be recovered for security purposes, you 
must utilize the FULL ERASE function. 

 
Use the   Up or   Down buttons to select between the two options and press the   OK button to continue.  

 
Follow the instructions shown in Setting Counters on page 12 to continue. 
Once the counters have been set, press the   OK button to confirm. 
 
The Robotic Arm will pick the discs to be erased from the Input Spindles 
and place them into the drives. As soon as the drives are all full, or the 
number programmed into the counter is reached, you will see the following: 
 
The system will check all discs in the drive and prepare them to be erased. 
As soon as the checking process completes, the Erase RW process starts.