caddx nx-4 Manual
6
Ready Light
The
ready light
is “on” when the system is ready to arm and “flashes” if ready to
force arm. The
ready light
is off when the system is not ready to arm because
of a zone(s) being faulted.
Stay Light
The
stay light
is “on” when the all interior (motion detector) zones are
bypassed.
Zone Light
The
zone lights
are “off” when everything is normal. A
zone light
will be “on” if
the zone has been bypassed. If a
zone light
is “flashing”, that zone is in alarm
or has been faulted. If a
zone light
is “flashing” rapidly, it means that the zone is
in a trouble condition. Trouble conditions are:
Tamper
Hardware
Low Battery
Loss of Supervision
(A combination of Alarm/Fault and Tamper/Trouble will produce a rapid
“flashing” light for a short period of time, followed by a slow “flashing” light.)
“flashing” light for a short period of time, followed by a slow “flashing” light.)
EMERGENCY ACTIVATION KEYS
NOTES: You must press and hold these keys for 2 seconds to activate
these functions. Your system may not be programmed for these activation
keys (see page 1)
these functions. Your system may not be programmed for these activation
keys (see page 1)
. You should press these keys only in an emergency situation
that requires response by emergency personnel. If your system is programmed
for these functions, the following reports can be sent.
for these functions, the following reports can be sent.
Fire Key – This key can activate the fire alarm when pressed for two seconds. If
your system is connected to a monitoring center, an emergency report could be
sent to that center.
your system is connected to a monitoring center, an emergency report could be
sent to that center.
Auxiliary Emergency Key – This key can activate the auxiliary alarm when
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be sent to that center.
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be sent to that center.
Police (Panic/Hold-Up) Key - This key can sound a local audible alarm when
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be transmitted to that center. NOTE: Some Panic/Hold-
Up alarms are programmed to be silent at the protected site while reporting an
alarm to the monitoring center. Check with your installing company to determine
how your security system will respond to the Panic/Hold-Up activation.
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be transmitted to that center. NOTE: Some Panic/Hold-
Up alarms are programmed to be silent at the protected site while reporting an
alarm to the monitoring center. Check with your installing company to determine
how your security system will respond to the Panic/Hold-Up activation.