eutech-instruments waterproof cyberscan pc 10 phconductivity meter Manual De Usuario

Instruction Manual

PC 10

- 5 -

3.2 Connecting

the

Probe

The Waterproof PC 10 meter uses a special combination pH / Conductivity / Temperature
probe. The probe cable has a notched 6-pin connector to attach the probe to the meter.

NOTE: Do not substitute other probes or electrodes. For replacement probe, see

the “Accessories” section, page 21-23.

NOTE: Keep connector dry and clean. Do not touch connector with soiled hands.

To connect the pH / Conductivity / Temperature probe:

1. Line up the notch and 6 pins of the meter’s connector with the holes in the probe’s

connector. Push down and screw the metal sleeve to lock the probe connector into
place. See Figure 5.

2. To remove probe, unscrew the metal sleeve and slide up the probe connector. While

holding onto metal sleeve, pull probe away from the meter.

CAUTION: Do not pull on the probe cord or the probe wires might disconnect.

Figure 5: Probe Connector