lift-master tcg2 Manual De Usuario
CAUTION:
To avoid possibility of duplicating
codes in adjacent systems, all transmitters and
receivers should be re-coded prior to operation.
Unless using maximum number of codes the
following four codes should not be used:
· All DIP Switches ON
· All DIP Switches OFF
· DIP Switches alternating ON/OFF
· DIP Switches alternating OFF/ON.
receivers should be re-coded prior to operation.
Unless using maximum number of codes the
following four codes should not be used:
· All DIP Switches ON
· All DIP Switches OFF
· DIP Switches alternating ON/OFF
· DIP Switches alternating OFF/ON.
Receivers should be installed at least 5 feet apart to
avoid cross-talk. After completing installation,
operate transmitter outside of building to make
certain the chosen DIP switch setting does not
operate with nearby garage door operators and/or
security systems. If so, select another DIP switch
setting and check the coded signal again. Repeat as
necessary.
avoid cross-talk. After completing installation,
operate transmitter outside of building to make
certain the chosen DIP switch setting does not
operate with nearby garage door operators and/or
security systems. If so, select another DIP switch
setting and check the coded signal again. Repeat as
necessary.
RECEIVER MOUNTING
Mount receiver to wall using #6 hardware (Not
Supplied). Hardware used will depend on mounting
application. (Refer to figure 1 for receiver mounting
hole locations).
Mount receiver to wall using #6 hardware (Not
Supplied). Hardware used will depend on mounting
application. (Refer to figure 1 for receiver mounting
hole locations).
ANTENNA MOUNTING
Screw on antenna clockwise and slide rubber boot
down to meet o-ring.
Screw on antenna clockwise and slide rubber boot
down to meet o-ring.
POWER & OUTPUT RELAY SWITCH SETTINGS
24V AC/DC
CH1 N/O
CH2 N/O
P3
12V 24V
CH1
MODE
CST MNT
CH2
MODE
CST MNT
RELAY
CH1-MODE
RELAY
CH2-MODE
JUMPER
(P3)
MOUNTING HOLES
(4 CORNERS)
FIGURE 1
2
Step 1 Power Supply Selection Setting
The TriCode
The TriCode
TM
receiver is factory set for 24 volt power
input if 12 volt is required.
Remove front cover of receiver by turning screws
counterclockwise a 1/4 of a turn until each releases.
Set jumper (P3) to either 12 or 24 volt setting
depending on your power input (Refer to figure 1).
counterclockwise a 1/4 of a turn until each releases.
Set jumper (P3) to either 12 or 24 volt setting
depending on your power input (Refer to figure 1).
Step 2 Setting Output Relay Mode
The TriCode
The TriCode
TM
receiver is factory set for momentary
relay output “MNT”.
(a) Momentary mode: The output relay will be on for
.5 seconds before turning off.
.5 seconds before turning off.
(b) Constant pressure mode: Output relay is
continuously on while receiving matching/valid ID
code from transmitter. The output relay will turn off
immediately once receiver does not received a
matching/valid ID code from the transmitter.
If constant pressure mode is desired, move mode
jumper from “MNT” to “CST” (Refer to figure 1).
continuously on while receiving matching/valid ID
code from transmitter. The output relay will turn off
immediately once receiver does not received a
matching/valid ID code from the transmitter.
If constant pressure mode is desired, move mode
jumper from “MNT” to “CST” (Refer to figure 1).
NOTE: The relay output is an isolated normally open
contact.
contact.