husky-liners 5645 front Manual De Usuario
PART NO.
5645
5645 Front Instructions.doc
Rev: 0
98-01 FORD EXPLORER w/o flares or running boards
FRONT MUD GUARD
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required:
•
1/8” drill bit / Drill
•
Center punch / Hammer
•
Short Phillips screwdriver
•
Marking utensil (fine tip marker, grease pencil, etc.)
Package Contents
•
Driver & passenger side mud guard
•
#10 screws (qty. 6)
•
Instruction sheet
NOTE:
Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary
to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove existing factory fasteners from locations B and C (Figure 1).
3. Attach mud guard to front fender with factory fasteners at locations B and C, check fit and level before tightening.
4. Using mud guard as a template, mark, center punch, and drill 1/8” holes at locations A, D, and E (Figure 1).
5. Attach mud guard to fender with a #10 screws at locations A, D, and E.
2. Remove existing factory fasteners from locations B and C (Figure 1).
3. Attach mud guard to front fender with factory fasteners at locations B and C, check fit and level before tightening.
4. Using mud guard as a template, mark, center punch, and drill 1/8” holes at locations A, D, and E (Figure 1).
5. Attach mud guard to fender with a #10 screws at locations A, D, and E.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer