husky-liners 5740re Manual De Usuario
PART NO.
5740
5740RE~1.DOC
Rev: 2
99-01 FORD SUPER DUTY REAR MUD GUARD
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
•
1/8” drill bit / Drill
•
Center punch / Hammer
•
Short Phillips screwdriver or drill attachment
Package Contents
•
Driver & passenger side rear mud guard
•
#10 screw (qty. 8)
•
U-clip (qty. 6)
•
Instruction sheet
NOTE: It may be necessary to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Install a U-clip at location B and C (Figures 1 & 3).
3. Attach mud guard to rear fender with #10 screw at location B and C, check fit before tightening.
4. Center punch and drill 1/8” hole before installing a #10 screw at location A.
5. Drill a 1/8” hole at location D.
6. Install a #10 screw through location D and into a U-clip on the backside of the liner (Figure 3).
2. Install a U-clip at location B and C (Figures 1 & 3).
3. Attach mud guard to rear fender with #10 screw at location B and C, check fit before tightening.
4. Center punch and drill 1/8” hole before installing a #10 screw at location A.
5. Drill a 1/8” hole at location D.
6. Install a #10 screw through location D and into a U-clip on the backside of the liner (Figure 3).
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer