kvh 01027702bk install Manual De Usuario
c. Place a rubber spacer onto the end of each
rubber mounting block.
Adding a Rubber Spacer to the Mounting Block (If Needed)
3. With the antenna centered on the vehicle’s roof
and resting on the four mounting blocks, mark the
eight mounting hole locations. To mark the holes,
you can use either a transfer punch or a
eight mounting hole locations. To mark the holes,
you can use either a transfer punch or a
21
⁄
64
" drill
bit as shown below.
Marking the Mounting Holes Using a
21
⁄
64
" Bit
4. Keeping the antenna level at all times, carefully
remove the antenna and mounting blocks from the
vehicle’s roof and set them aside in a safe place.
vehicle’s roof and set them aside in a safe place.
5. Using a
7
⁄
16
" drill bit, drill the eight mounting holes
in the vehicle’s roof. Be careful to drill through just
the metal roof, and not through the headliner
beneath it.
the metal roof, and not through the headliner
beneath it.
3
TracVision A7 Installation Guide – ADDENDUM
54-0350 Addendum to Rev. A
Bracket
Plastic Spacer
Rubber Spacer
Mounting Block