Belinea 1705 s1 Manual De Usuario

Belinea 1705 S1 - Operating Instructions -

INTRODUCTION ......................................................... 2

IMPORTANT INFORMATION ..................................... 3

CARING FOR yOUR LCD MONITOR ........................ 3

WALL MOUNTING ...................................................... 3

UNPAckING ............................................................... 4

CONNECTING ............................................................ 4

STARTUP .................................................................... 4

CONFIGURATION ...................................................... 5

BASIc SETUP ............................................................ 5

IMAGE SETTINGS USING THE OSD MENU ............ 5

OSD MENU FUNCTIONS ........................................... 6

TROUBLESHOOTING ................................................ 7

TECHNICAL SPECIFICATIONS ................................. 7

DEFINITION OF THE MAxDATA WARRANTy ......... 8

We are all responsible for the environment: this manual was printed from front to back on 

paper that was produced without chlorine.

This manual will familiarize you with the installation and 

use  of  your  Belinea  monitor.  Please  take  the  time  to 

look through these instructions even if you are familiar 

with monitors. 
We  have  taken  all  possible  care  to  ensure  that  this 

manual contains correct, accurate information. However, 

the manufacturer cannot assume liability for any possible 

errors. In addition, the manufacturer cannot guarantee 

that the hardware will meet the purpose you require. We 

would appreciate reports of any errors, suggestions or 

criticism.

©  copyright 2006 

 MAxDATA Systeme GmbH 

 45768 Marl, Germany 

  www.maxdata.com

Editing, DTP and translation by think’Z GmbH,

www.thinkz.de.
All  rights  reserved.  No  part  of  this  manual  may  be 

reproduced, processed or distributed in any form (print, 

photocopy, microfilm or any other process) or processed

by an electronic system without prior written permission 

from the manufacturer. 

We reserve the right to make changes according to technical 

progress. Belinea is an internationally registered trademark. 

Other brand names may be registered trademarks and must

be treated as such.  

The symbols below are used in this manual to indicate 

where there is risk of injury or damaging devices or to

indicate especially useful information:

DANGER! Indicates risk of injury. When not

following instructions, severe injury or death

may result.
ATTENTION!  Indicates  possible  damage

to devices. When not following instructions, 

devices may be heavily damaged.
IMPORTANT!  Indicates  hints  on  operation

and other useful information.

Some Belinea monitor models come with 2 power cords. 

Please ensure you use the UK plug (3 pin) in the UK and

not the European plug (2 pin).
Do not place the monitor in very hot or cold, nor damp or 

dusty surroundings. Do not put vases etc. on the monitor, 

water may cause short circuits. Do not block or cover the 

ventilating openings. Do not install this monitor in areas 

where too much light or sunshine might directly hit the 

screen, otherwise the brightness of the picture will be 

poor due to reflections. Refer all servicing and mainte-

nance to authorised service personnel only!

Do not remove the cover!

Serious electrical shock hazards exist inside 

this monitor.
NoTE

Removal of cover invalidates your warranty.