husky-liners 2110 Manual De Usuario

2110.DOC

Rev: 0

01/26/01

CARE AND USE INSTRUCTIONS

      Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not

completely unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back

of your vehicle with a weight in each corner (a book works well). After about 15 minutes, your liner will remain

flat. In colder climates this “relaxing” may take longer; moving the liner inside will speed up the process.

     Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable.

The easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409

®

 or Glass Plus

®

 work

well. Use of Armor All

®

, Son-of-a-Gun

®

 or similar items is discouraged as these products make the liner slick.

TO INSTALL YOUR THIRD SEAT
WITH THE LINER IN PLACE,
TRIM AWAY THE MATERIAL
INSIDE OF THE RAISED BANDS
(SHOWN DARKENED). A UTILITY
KNIFE WORKS WELL.YOU MAY
REMOVE THE FACTORY TRIM
BEZELS FROM THE CARPET AND
RE-INSTALL OVER YOUR HUSKY
LINER. THE BEZELS WILL COVER
THE RAISED BANDS.

TO ACCESS YOUR FACTORY CARGO TIE-DOWN
HOOKS WITH YOUR LINER IN PLACE, SLIT THE
FOUR SMALLER RAISED AREAS SHOWN CIRCLED
AND PULL THE HOOKS UP THROUGH THE LINER.