brax x2000 Manual De Usuario

Signal input for the left and right channels. Both inputs are

marked  red. Connect using an RCA cable with cinch

connectors.

Signal output for driving additional amplifier modules.

The signal depends on the Circuit Control Card inserted

per channel (see page 9). Both outputs are marked white.

The speakers are connected here in accordance with the

required configuration (see Figs. 5 to 7). Cable sizes of up

to 6 mm

2

/gauge 10 can be employed for this purpose.

The level controller enables the input sensitivity of the

BRAX amplifiers to be adapted to the output voltage of the

connected control unit (radio/tuner). This controller is not

a volume control. Optimum setting of the level controller

ensures you maximum audio enjoyment without those all-

too-common audible distortions and overshoot phenomena

which have such an adverse effect on sound quality.

This shows the operating status of your amplifiers. When the

amplifier module is switched on, both LED’s briefly light up

red and then change to green. This means that both channels

of the module are operational. In the event of a malfunction

in the amplifier module or a short circuit at the output, the

LED for the defective or short-circuited channel switches to

yellow. In the event of an amplifier channel overheating, the

associated LED switches to red.

Green = operational; Yellow = malfunction in the ampli-

fier, short circuit at the speaker output; Red = overheating. 

If the amplifier has tripped owing to overheating, it may

take some time, depending on the ambient temperature,

before it is re-activated.

Terminal for connecting the positive 12-volt power supply

cable, the ground/chassis lead and the remote lead.

The power ON LED lights up green when the amplifier is

switched on. In the event of one of the two channels

overheating, the LED switches to red.

Sockets are located at the bottom of the amplifier for plug-

ging in the Circuit Control Cards for the left (9) and the

right (10) channels.

10