Panasonic KX-TG1000N Manual De Usuario

“SEARCHING FOR BASE” is
displayed and an alarm tone
sounds.

The unit does not work.

When you try to make a call,
the other voice is heard.

You cannot dial.

Static, sound cuts in/out,
fades. Interference from
other electrical units.

The handset does not ring.

•You are too far from the base unit. Move

closer and try again.

•Place the handset on the base unit and

unplug the AC adaptor to reset. Plug in,
and try again.

•Re-install the handset battery and place

the handset on the base unit (p. 11, 65).
Try again.

•Check the settings (p. 10–13).

•Charge the handset battery fully (p. 11).

•Clean the charge contacts and charge

again (p. 12).

•Install the handset battery properly 

(p. 11, 65).

•Place the handset on the base unit and

unplug the AC adaptor to reset. Plug in,
and try again.

•Re-install the handset battery and place

the handset on the base unit (p. 11, 65).
Try again.

•The handset has not been registered.

Register the handset (p. 54). 

•The handset or base unit is engaged in

an external call. If you are using the
handset, wait until “LINE IN USE”
disappears. If you are using the base
unit, wait until the IN USE indicator light
goes out.

•Check whether the dialing mode

selection is correct (p. 13).

•Locate the handset and the base unit

away from other electrical appliances
(p. 3).

•Move closer to the base unit.
•The ringer volume is set to OFF. 

Select the desired volume level (p. 16).