Panasonic PTLZ370E Guía De Operación

▶

z

Select the [PICTURE] menu → [ADVANCED 

MENU] and press ◀▶ to adjust [BRIGHTNESS 

B] and then [CONTRAST B].

Adjusts the black level of the 

display signal to 0% (0 IRE or 

7.5 IRE).

 

z

Setting range

-16 to +16

Adjusts the white level of the 

display signal to 100% (100 IRE).

 

z

Setting range

-32 to +32

▶

■To set [MONITOR POSITION]

You can set the display position of the input waveform 

during the full scan display.

Press ◀▶ to switch [MONITOR POSITION].

 

z

The setting will change as follows each time you 

press the button.

[UPPER LEFT] Displays the input waveform on 

the upper left.

Displays the input waveform  on 

the upper center.

[UPPER RIGHT] Displays the input waveform on 

the upper right.

[LOWER LEFT] Displays the input waveform on 

the lower left.

Displays the input waveform on 

the lower center.

Displays the input waveform on 

the lower right.

▶

■To set [AUTO ADJUST]

The luminance level of the output signal from a 

connected external device is automatically adjusted 

by setting the automatic waveform adjustment items.

1)  Press ▲▼ to select an adjustment 

[START AUTO ADJUST]

—

[BLACK LEVEL ADJUST]

[ON]

[WHITE LEVEL ADJUST]

[ON]

[RGB ADJUST (BLACK)]

[OFF]

[RGB ADJUST (WHITE)]

[OFF]

2)  Press ◀▶ to switch the adjustment.
3)  Press ▲▼ to select [START AUTO 

▶

z

The [PROCESSING] message is displayed. 

When adjustment is complete, a confirmation 

message for applying results is displayed.

4)  Press ◀▶ to select [OK].
5)  Press the <ENTER> button.

 

z

When [BLACK LEVEL ADJUST] is [ON], the 

display signal Y (brightness) value’s black level is 

automatically adjusted to the 0% position.

 

z

When [WHITE LEVEL ADJUST] is [ON], the 

display signal Y (brightness) value’s white level is 

automatically adjusted to the 100% position.

 

z

When [RGB ADJUST (BLACK)] is [ON], the display 

signal R (Red), G (Green), and B (Blue) value’s 

black level are all automatically adjusted to the 0% 

position.

 

z

When [RGB ADJUST (WHITE)] is [ON], the display 

signal R (Red), G (Green), and B (Blue) value’s 

white level are all automatically adjusted to the 

100% position.

 

z

If [WAVEFORM MONITOR] is [OFF], [AUTO 

ADJUST] cannot be executed.

 

z

Project the luminance adjustment signal of a 

commercial test disk etc., and perform automatic 

adjustment. However, even with an adjustment 

disk, correct adjustment may not be possible if 

noise is included on the disk itself or the playback 

device generates noise.