Panasonic MCUL594 Guía De Operación

12

•  Check HEPA filter unit frequently and clean when dirty.

•  Remove HEPA filter unit from dust bin by pulling both buckle as shown.

•  Clean HEPA filter unit by gently tapping over a rubbish container. 

  Tap on Lid several sides to ensure best cleaning. 

  DO NOT clean the HEPA filter unit by brush or clean it with water.

•  Reinstall the HEPA filter unit as per reverse procedure.

•  Remove HEPA filter unit from dust bin. Refer to maintaining the HEPA  

  filter unit (as above).

•  Press the latch to open the dust bin plate.

•  Grasp the pre-filter and turn it clockwise and pull the pre-filter out as shown.

  Clean by gently tapping over a rubbish container.

•  Install the pre-filter to the dust bin, aligning the pre-filter tabs to the dust  

  bin slots. Each Pre Filter Tabs is different shape and adjust it to match  

  Dust Bin Slot, then turn counter-clockwise to the lock position until you  

  hear a “click” sound as shown.

•  After the dust bin is empty, firmly close the dust bin plate. 

  Make sure you hear a “click” sound to indicate that the dust bin plate is  

  fully latched.

•  Reassemble the HEPA filter unit. Place dust bin unit back into vacuum  

  cleaner by inserting the bottom first and tilting back. 

  Refer to dust bin cleaning (pg.10).

Pull to release

Pull to release

Buckle

Dust Bin

HEPA Filter

Unit

Pre-Filter Tab

Dust Bin Slot

Pre-Filter

Lid