Panasonic TH-65VX300ER Guía De Operación

Adjusts the image display size on screen.

Off:  Sets the normal image display size on screen.

On:  Sets the image display size approximately 95 % of the normal image display.

Notes:
• This setting is valid only when the input signals are as follows; 
  NTSC, PAL, SECAM, M.NTSC, PAL60, PAL-M, PAL-N (Video)

525i, 525p, 625i, 625p, 750/60p, 750/50p, 1125/60i, 1125/50i, 1125/24sF, 1125/25p, 1125/24p, 
1125/30p, 1125/60p, 1125/50p, 1250/50i (Component Video, RGB, DVI, SDI, HDMI)

• When “Display size” is set to “On”, “H-Pos” and “V-Pos” in “Pos./Size” can be adjusted. 
• Refer to each board’s operating instruction for DVI, SDI, HDMI’s corresponding signals.

Sets All Aspect mode (advanced aspect setting) or default aspect mode.
With each press of 

 button, the aspect changes in the selected mode.

Off:  Default aspect mode

On: All Aspect mode

Aspect mode of each setting is as follows:

(Example: HD signal)

Off 4:3→4:3 Full→Zoom1→Zoom2→Zoom3→16:9→14:9→Just

On 4:3 (1)→4:3 (2)→4:3 Full→Zoom1→Zoom2→Zoom3→16:9→14:9→Just1→Just2

Sets the operational mode of the automatic position adjustment in the Pos./Size menu.
Manual:   Automatic position adjustment starts when 

 is pressed on the remote control or 

automatic position adjustment is executed from the Pos./Size menu.

Auto: 

 Other than remote control or menu operation, automatic position adjustment starts:

When the display power is turned ON.

When the input signal is switched.

Displays motion picture images at higher resolution.
On 

Notes:
• Please set to “Off” if images look unnatural.
• This function is disabled during 3D images.

Whether to show/hide No activity power off Precautions at the time of power ON is set.

On:  The warning precautions are shown at the time of power ON.

Off:  The warning precautions are not shown at the time of power ON.

Note:  This setting is enabled only if “No activity power off” is “Enable” (see page 43).

3D Safety Precautions show/hide is set during power ON.

On:  3D Safety Precaution is shown every time when the power is ON.

Off:  3D Safety Precaution is not shown when the power is ON.

When the setting changes from “On” to “Off”, the confi rmation screen is displayed as below. 

Pressing “YES” switches the setting.

YES 

     NO

3D Safety Precautions

If Off is selected, the 3D safety precautions 
will not be displayed when power is turned on.
Change Setting?

Locks or unlocks saved profi les. Also for setting passwords. (see page 38)