Panasonic th-152ux1 Guía De Operación
11
Accessories Supply
Accessories
Fixing band × 3
TMME203
TMME203
Nut cover × 3
(M20)
(M20)
Nut cover × 3
(M16)
(M16)
Batteries for the Remote
Control Transmitter
(R6 (AA) Size × 2)
Control Transmitter
(R6 (AA) Size × 2)
Remote Control Transmitter
N2QAYB000560
N2QAYB000560
Operating Instruction book
Check that you have the accessories and items shown
Remote Control Batteries
Requires two R6 (AA) batteries.
1. Pull and hold the hook, then open the battery cover.
1. Pull and hold the hook, then open the battery cover.
2. Insert batteries - note correct polarity ( + and -).
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline
batteries for longer life.
batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, fi re or the like.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, fi re or the like.
“R6 (AA)” size
Hook
Open
Close
These accessories will be used by professional installers when they install the unit.
Bolt × 3
Power cable fi xing
plate A × 2
plate A × 2
Power cable fi xing
plate B × 2
plate B × 2
Allen wrench