Puls UC10.242 DIN-Rail UPS Guia De Especificaciones

UC10.241, UC10.242

UC-Series

24V,

15A,

APACITOR

BASED

UFFER

ODULES

5. C

HARGING

During charging, the buffer module consumes additional current from the input. See chapter “Input”.

When charging is completed, the “Ready LED” stops flashing and is on solid and the “Ready relay contact” closes.

UC10.241 UC10.242

Charging time
initial

charging

typ.

16 minutes

32 minutes

when capacitor is completely discharged

Charging time
recharging

**)

typ.

1 minute 50s

after discharging with 10A for 10s

typ.

3 minutes 50s

7 minutes 40s

after discharging with 10A until buffering
stops

typ.

4 minutes 40s

9 minutes 40s

after discharging with 5A until buffering
stops

typ.

5 minutes 40s

11 minutes 15s

after discharging with 1A until buffering
stops

Allowed number of charging /
discharging cycles

no limitation

Initial charging means that no input voltage was applied for several hours or longer and the capacitor is completely discharged by the
internal electronics.

**) Recharging means that the electronics inside the buffer module has not completely discharged the capacitor. The values in the table

apply when the input voltage is applied immediately after buffering has stopped.

Note:
At the end of the charging process the active balancing circuit reduces the charging current periodically, which can be
seen as current oscillations on the input current.

Apr. 2014 / Rev. 2.0 DS-UC10.241-EN (REVC)
All parameters are specified at 24V, 10A output current, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0 Germany

7/27