Canon EOS 5DS (no lens included) Manual De Propietario

471

If a problem occurs with the camera, first consult this Troubleshooting 
Guide. If this Troubleshooting Guide does not resolve the problem, 
contact your dealer or nearest Canon Service Center.

 

If the battery’s remaining capacity is 94% or higher, the battery will not 
be recharged (p.446).

 

Do not use any battery other than genuine Battery Pack LP-E6N/LP-
E6.

 

If (1) the battery charger or battery has a problem or (2) communication 
with the battery failed (with a non-Canon battery pack), the protection 
circuit will stop charging, and the charge lamp will blink in orange at a 
high speed. In the case of (1), unplug the charger’s power plug from the 
power outlet. Detach and reattach the battery to the charger. Wait a few 
minutes, then reconnect the power plug to the power outlet. If the 
problem persists, contact your dealer or nearest Canon Service Center.

 

If the internal temperature of the battery attached to the charger is 
high, the charger will not charge the battery for safety reasons (lamp 
off). During charging, if the battery’s temperature becomes high for 
any reason, charging will stop automatically (lamp blinks). When the 
battery temperature goes down, charging will resume automatically.

 

Make sure the battery compartment cover is closed 

(p.

)

.

 

Make sure the battery is installed properly in the camera (p.42).

 

Recharge the battery (p.40).

 

Make sure the card slot cover is closed 

)

.

The camera does not operate even when the power switch is set to <1>.