Sony CDX-G1200U Manual De Propietario

Descargar
Página de 29
17
GB
– Neither the name of the Xiph.org 
Foundation nor the names of its 
contributors may be used to endorse or 
promote products derived from this 
software without specific prior written 
permission.
THIS SOFTWARE IS PROVIDED BY THE 
COPYRIGHT HOLDERS AND CONTRIBUTORS 
“AS IS” AND ANY EXPRESS OR IMPLIED 
WARRANTIES, INCLUDING, BUT NOT LIMITED 
TO, THE IMPLIED WARRANTIES OF 
MERCHANTABILITY AND FITNESS FOR A 
PARTICULAR PURPOSE ARE DISCLAIMED. IN 
NO EVENT SHALL THE FOUNDATION OR 
CONTRIBUTORS BE LIABLE FOR ANY DIRECT, 
INDIRECT, INCIDENTAL, SPECIAL, 
EXEMPLARY, OR CONSEQUENTIAL DAMAGES 
(INCLUDING, BUT NOT LIMITED TO, 
PROCUREMENT OF SUBSTITUTE GOODS OR 
SERVICES; LOSS OF USE, DATA, OR PROFITS; 
OR BUSINESS INTERRUPTION) HOWEVER 
CAUSED AND ON ANY THEORY OF LIABILITY, 
WHETHER IN CONTRACT, STRICT LIABILITY, 
OR TORT (INCLUDING NEGLIGENCE OR 
OTHERWISE) ARISING IN ANY WAY OUT OF 
THE USE OF THIS SOFTWARE, EVEN IF 
ADVISED OF THE POSSIBILITY OF SUCH 
DAMAGE.
Troubleshooting
The following checklist will help you remedy 
problems you may encounter with your unit.
Before going through the checklist below, 
check the connection and operating 
procedures.
For details on using the fuse and removing 
the unit from the dashboard, see 
“Connection/Installation” (page 21).
If the problem is not solved, visit the support 
site on the back cover.
General
No power is being supplied to the unit.
 If the unit is turned off and the display 
disappears, the unit cannot be operated 
with the remote commander.
– Turn  on  the  unit.
No sound or the sound is very low.
 The position of the fader control [FADER] 
is not set for a 2-speaker system.
 The volume of the unit and/or connected 
device is very low.
– Increase the volume of the unit and 
connected device.
No beep sound.
 An optional power amplifier is connected 
and you are not using the built-in 
amplifier.
The contents of the memory have been 
erased.
 The power supply lead or battery has 
been disconnected or not connected 
properly.
Stored stations and correct time are 
erased.
The fuse has blown.
Makes a noise when the position of the 
ignition is switched.
 The leads are not matched correctly with 
the car’s accessory power connector.