Boyo VTB201MA Manual De Propietario
V T B 2 0 1 M A Q U I C K I N S T A L L A T I O N G U I D E
Quick Installation Guide
1. System Overview
One VTB201MA high resolution HD CMOS color camera
with the following features:
with the following features:
y
Weatherproof and water reistant
y
Mirror/ Non-Mirror image selectable switch
y
Wide-angle lens 170
°
y
Built-in Microphone
y
360-degree adjustable mounting angle
y
Auto-iris lens that automatically adjusts to light conditions
y
Infrared light for improved image quality in low-light
situations
situations
y
Nightvision distance of approx 8M
20M Extension Cable Included
Supplied installation accessories
2. Installation
Install the VTB201MA as follows:
a.
Install the VTB201MA camera in the desired location, as
follows:
follows:
1)
Fasten the camera mounting bracket, using the 4 self-
tapping Philips screws, to the desired mounting
surface, as shown in the Step 1 arrows of Figure 1.
tapping Philips screws, to the desired mounting
surface, as shown in the Step 1 arrows of Figure 1.
2)
Position the camera in the camera mounting bracket.
Adjust the camera to the proper angle, and then attach
the camera and sun visor to the camera mounting
bracket using the 4 supplied hex-head machine screws
(with washers), as shown in the Step 2 and Step 3
arrows of Figure 1.
Adjust the camera to the proper angle, and then attach
the camera and sun visor to the camera mounting
bracket using the 4 supplied hex-head machine screws
(with washers), as shown in the Step 2 and Step 3
arrows of Figure 1.
Figure 1. Installing the Camera
b.
Route the extension cable from the camera location to the
location of the output device (not supplied), such as a
monitor or switcher.
location of the output device (not supplied), such as a
monitor or switcher.
c.
Insert the male connector of the extension cable into the
appropriate female audio/video port of the output device
(not supplied), such as a monitor or switcher.
appropriate female audio/video port of the output device
(not supplied), such as a monitor or switcher.
3. Normal/Mirror Selector
The camera default setting is in reverse viewing. To change to
non-mirror viewing, unplug the jumper plug with the green wires
and re-power the camera for the changes to take effect.
non-mirror viewing, unplug the jumper plug with the green wires
and re-power the camera for the changes to take effect.
4. Grid Line Selector
The camera default setting is grid line on. To turn off the grid
lines, unplug the jumper plug with the blue wires and re-power
the camera for the changes to take effect.
lines, unplug the jumper plug with the blue wires and re-power
the camera for the changes to take effect.
5. Specifications
Item
Specification
Image Sensor
1/3 1089
TV System
NTSC
Effective Pixels
720 x 480
Minimum Illumination
0.0 Lux
Power Consumption
12 VDC, 250mA Max
Operating Temperature
-20°C to 70°C
Dimensions
(Width x Height x Depth)
(Width x Height x Depth)
3 inches x 3 inches x 2.25 inches
Lens Angle
170°
Supplied Accessories
Manual
Screws
20M Extension cable
DC Power cable
2 Jumper terminals
Warranty card
Registration card
CAUTION: To reduce the risk of electrical shock, disconnect the
battery from the electrical system of the vehicle before
starting the installation.
starting the installation.
CAUTION: Before inserting screws into the mounting surface,
ensure that the underside of the mounting surface is
clear of equipment that might be damaged by the
screws.
clear of equipment that might be damaged by the
screws.