Brandmotion FDMC-1260 Manual De Propietario
1260 Instructions 6-26-14.docx
Page 4 of 5
Step 12: Place Freedom Charge Module and
rubber tray liner into upper console trim.
Make sure to fully snap in rubber liners
rubber tray liner into upper console trim.
Make sure to fully snap in rubber liners
Step 13: Using a center punch/scribe tool
mark the location of the (2) chamfered holes
through Charging Module onto rubber tray
liner.
mark the location of the (2) chamfered holes
through Charging Module onto rubber tray
liner.
Step 14: Swing Charging Module away and
Drill (2) 1/8” holes through rubber tray liner
and upper console trim.
Drill (2) 1/8” holes through rubber tray liner
and upper console trim.
Step 15: Insert the (2) 1” Flat Head T-10
Torx Screws through Charging Module and
rubber tray liner into upper console tray.
Step 16: Install Non-Slip Freedom Charge
Mat to Wireless Charging Module. Place the 4
locator pins in corresponding holes.
Mat to Wireless Charging Module. Place the 4
locator pins in corresponding holes.