Brandmotion FDMC-1272 Manual De Propietario
1272Instructions11-26-14.doc Page
3
of
6
Step 7: Route connector of charging module
through ½” hole and place module in tray.
through ½” hole and place module in tray.
Step 8: Align the (4) 3/16” holes with
mounting holes on module and insert the (4)
3/8” Pan Head T-20 Torx Screws through
tray into module.
mounting holes on module and insert the (4)
3/8” Pan Head T-20 Torx Screws through
tray into module.
Step 9: Drill the (1) 1/2” hole in rear driver
side of lid as shown.
side of lid as shown.
Step 10: Route connector of charging module
through ½” hole and place top tray back to
original location.
through ½” hole and place top tray back to
original location.
Step 11: Using a Phillips Screw Driver
reassemble top tray.
reassemble top tray.
Step 12: Place plastic substrate onto module
and using Torx driver secure using 1/4” flat
head screws.
and using Torx driver secure using 1/4” flat
head screws.