Sony DXS-M5511BT Marine Package Manual De Propietario

Descargar
Página de 60
3
GB
This device complies with Part 15 of the FCC Rules 
and Industry Canada's licence-exempt RSSs. 
Operation is subject to the following two 
conditions: 
(1) This device may not cause interference; and 
(2) This device must accept any interference, 
including interference that may cause undesired 
operation of the device.
This transmitter must not be co-located or operated 
in conjunction with any other antenna or 
transmitter.
Under Industry Canada regulations, this radio 
transmitter may only operate using an antenna of a 
type and maximum (or lesser) gain approved for 
the transmitter by Industry Canada. To reduce 
potential radio interference to other users, the 
antenna type and its gain should be so chosen that 
the equivalent isotropically radiated power (e.i.r.p.) 
is not more than that necessary for successful 
communication.
This equipment complies with FCC/IC radiation 
exposure limits set forth for an uncontrolled 
environment and meets the FCC radio frequency 
(RF) Exposure Guidelines and RSS-102 of the IC 
radio frequency (RF) Exposure rules. This 
equipment has very low levels of RF energy that is 
deemed to comply without maximum permissive 
exposure evaluation (MPE).
For the State of California, USA only
Perchlorate Material – special handling may apply, 
See
www.dtsc.ca.gov/hazardouswaste/perchlorate
Made in Thailand
Hereby, Sony Corporation, declares that this 
equipment is in compliance with the essential
requirements and other relevant provisions of 
Directive 1999/5/EC.
For details, please access the following URL:
http://www.compliance.sony.de/
Notice for customers: the following 
information is only applicable to equipment 
sold in countries applying EU Directives
Manufacturer: Sony Corporation, 1-7-1 Konan 
Minato-ku Tokyo, 108-0075 Japan
For EU product compliance: Sony Belgium, 
bijkantoor van Sony Europe Limited, Da Vincilaan 
7-D1, 1935 Zaventem, Belgium
Disposal of waste batteries and 
electrical and electronic 
equipment (applicable in the 
European Union and other 
European countries with separate 
collection systems)
This symbol on the product, the battery or on the 
packaging indicates that the product and the 
battery shall not be treated as household waste. On 
certain batteries this symbol might be used in 
combination with a chemical symbol. The chemical 
symbols for mercury (Hg) or lead (Pb) are added if 
the battery contains more than 0.0005% mercury or 
0.004% lead. 
By ensuring these products and batteries are 
disposed of correctly, you will help prevent 
potentially negative consequences for the 
environment and human health which could 
otherwise be caused by inappropriate waste 
handling. The recycling of the materials will help to 
conserve natural resources.
In case of products that for safety, performance or 
data integrity reasons require a permanent 
connection with an incorporated battery, this 
battery should be replaced by qualified service staff 
only. 
To ensure that the battery and the electrical and 
electronic equipment will be treated properly, hand 
over these products at end-of-life to the applicable 
collection point for the recycling of electrical and 
electronic equipment. For all other batteries, please 
view the section on how to remove the battery from 
the product safely. Hand the battery over to the 
applicable collection point for the recycling of 
waste batteries. 
For more detailed information about recycling of 
this product or battery, please contact your local 
Civic Office, your household waste disposal service 
or the shop where you purchased the product or 
battery.