Clarion GR10BT Manual De Propietario

English

Owner’s Manual

12

1. This set is exclusively for use in vessels with a negative ground 

12 V power supply.

2. Read these instructions carefully.
3. Be sure to disconnect the battery “–” terminal before starting. 

This is to prevent short circuits during installation. (Figure 1)

1. In order to avoid any interference, do not install the tuner module or control unit in the 

proximity of the engine compartment.

2. The use of unauthorized parts can cause permanent damage to the unit.
3. Always check your wire connections to ensure proper installation before turning on the unit.
4. Consult with your nearest dealer for proper installation or if common parts need to be used. 

5GGMCUUKUVCPEGKHOQFKſECVKQPUQTFTKNNKPIJQNGUVQ[QWTXGUUGNKUPGGFGF

5. Do not install the unit where it will be subjected to excessive moisture, dust, dirt, foreign 

particles or vibration. Areas of high temperature from the engine, direct sunlight, heater or hot 
air should also be avoided.

6. Do not install the unit in a location where it will interfere with the vessel operation, or it will 

injure the passengers if there is a sudden or emergency stop.

Instructions:
1. Install jamb nuts (4) loosely on mounting 

studs (3), so they will not touch mounting 
brackets (5) when installed.

2. Slip mounting bracket (5) on and make 

flush with mounting surface (2).

3. DO NOT TIGHTEN
4. Snug spring washer (6) and outer nuts (7) 

against mounting plate (2).

5. DO NOT TIGHTEN
6. Position jamb nuts approximately 1/16” 

from mounting bracket.

7. Tighten outer nuts completely.

Battery

Figure 1

NO. PART DESCRIPTION

1

MAIN DEVICE

2

MOUNTING SURFACE

3

MOUNTING STUDS

4

JAM NUTS

5

MOUNTING BRACKET

6

SPRING WASHER

7

OUTER NUTS