ClearView HD2-PTZ-4 Manual De Propietario

 

 

6 

 

Note: There are two outlet modes for ceiling mount installation.  

Don’t drill hole on the ceiling, and open wire outlet from the side of the speed dome. 

Drill hole on the ceiling, and concealed wire outlet from the ceiling.  

 

Install the default pedestal seal ring of the speed dome on the pedestal according to the way 

shown in Figure 3-1. 

Confirm installation position and outlet mode first, dig holes on the ceiling according to the 

installation position map, and then put the three plastic expansion bolts into the holes you just 

dug.  

Unscrew three locking screws on the enclosure by using inner hex wrench, and remove the 

enclosure.  

Lay the outgoing line according to the outlet mode, and use three self-tapping screws to fix the 

pedestal on the installation surface, and insert the screws into the expansion bolts.  

Adjust the lens to proper monitoring position according to the direction shown in Figure 3-1.  

Use three locking screws to fix the dome enclosure on the pedestal.  

So far, the camera installation and cable connection are completed, and you can check device 

monitoring view via back-end encoding device.