Marantz PM-10 Manual De Propietario

n How to set ID number for F.C.B.S.

When the unit is turned on, the display shows the ID

number for three seconds.
For a master unit, ID number 1 needs to be assigned.
For a slave unit, set any of ID numbers 2 to 4.

.

X

X.

0

The setting is saved.

0

The unit registered as a slave shows “SLAVE” on the

display.

0

If using this unit by itself as a stereo amplifier, set the ID

number to “0” (Default setting is “0”).

0

If the ID number is set to a number other than “0”, this unit

cannot be used for standalone operation.

This mode enables the two amplifiers connected to this unit

to function as one monaural amplifier. To use this mode, two

F.C.B.S. connected PM-10 units are required.
To switch the mode, use the AMPLIFIER MODE switch on

the rear panel while the power is off.
The figures below show example displays in the stereo and

bi-amp modes.

.

Stereo mode

Bi-amp mode

Bi-amp mode indicator

In bi-amp mode, connect to the left channel input jack. The

right channel input is disabled.
The same signals are output from the left and right speaker

terminals.

0

Always turn the power to the unit OFF before changing the

operating mode switch setting. Turning the power ON

again activates the new setting.

0

When in bi-amp mode, the R channel input jacks cannot be

used.

0

When in bi-amp mode, the signals input into the L channel

are output from both channels. Therefore, the same signals

are output from the L channel and R channel in

RECORDER OUT, headphones jack.

0

Speaker systems connected using complete bi-amp

connections must support bi-amp connections. Before

connecting your speakers, check in the instruction manual

that came with the speakers or contact the manufacturer to

confirm whether they support bi-amp connection.

ENGLISH

12