Comp X Security Products Inc 421860 Manual De Usuario

Descargar
Página de 117
BATTERY: TOURING MODELS
Disconnection and Removal
1.
Remove seat.
NOTE
The ECM caddy has an opening in the front right corner
allowing access to the negative battery terminal.
2.
See Figure 67. Press latches (2) away from the ECM (1)
and detach from ECM caddy (3).
3.
Remove fastener (4) from rear of ECM caddy.
4.
Remove ECM caddy from battery compartment.
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explosion,
which could result in death or serious injury. (00049a)
5.
See Figure 68. Unthread bolt and remove battery negative
cable (black) from battery negative (-) terminal.
6.
Unthread bolt and remove battery positive cable (red) from
battery positive (+) terminal.
7.
Pull up on strap to lift battery out from compartment.
Installation and Connection
Connect the cables to the correct battery terminals. Failure
to do so could result in damage to the motorcycle electrical
system. (00215a)
Connect positive (+) battery cable first. If positive (+) cable
should contact ground with negative (-) cable connected,
the resulting sparks can cause a battery explosion, which
could result in death or serious injury. (00068a)
Do not allow positive (+) battery cable to contact ground
with negative (-) cable connected. Resulting sparks can
cause a battery explosion, which could result in death or
serious injury. (00069a)
Maintenance and Lubrication   179