K-Mark Industrial Limited. GL-GUARDIAN Manual De Usuario

Instruction Manual

This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason-

able protection against harmful interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy and, if not installed and used in ac-

cordance with the instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which 

can be determined by turning the equipment off and on, the user is encouraged to try to 

correct the interference by one or more of the following measures:

  -- Reorient or relocate the receiving antenna.

  -- Increase the separation between the equipment and receiver.

  -- Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

  -- Consult the dealer or an experienced radio/TV technician for help.

Toll Free: 1-800-657-8214 
Outside US: 1-541-245-4488

Changes or Modifications not expressly approved by the party responsible could void the 

user’s authority to operate this device.

Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries  

according to the instructions. This product needs power supplied by an adapter that can 

meet LPS. The maximum operating temperature is 45°C.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is 

subject to the following two conditions: (1) this device may not cause interference, and (2) 

this device must accept any interference, including interference that may cause undesired 

operation of the device.

Website: www.pestrepellerultimate.com  
Email: customerservice@goodlifeinc.com

This device complies with part 15 of the FCC Rules. Operation is subject to the following 

two conditions: (1) this device may not cause harmful interference, and (2) this device 

must accept any interference received, including interference that may cause undesired 

operation.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils 

radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) 

l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter 

tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en comprom-

ettre le fonctionnement.

©2014 Good Life, Inc.     DESIGNED IN OREGON      MADE IN CHINA

The Guardian™ can be powered by 6 C size batteries or by an 

AC adapter. To install batteries, remove the two screws that 

hold the cover in place and remove the cover. Install the batter-

ies as shown and replace the cover.

When using the optional AC adapter, plug the adapter into the 

wall. Lift the rubber flap on The Guardian™ and attach the cord. 

Use the remote control to activate The Guardian™ if the pest is 

outside the motion detector range or too small to trigger the 

unit automatically.  

The Strobe Light connects via a small 2-pin plug and twists on 

top of The Guardian™. This optional accessory produces regular 

flashes of light that are irritating to nocturnal animals and can 

be used indoors or out. 

1)  Identify where your pest problem is.

2)  Adjust the control panel based on your particular pest  

problem (see Control Panel section for further directions)

3)  Place The Guardian™ at the pest’s level. If targeting smaller 

pests, put The Guardian™ lower to the ground and higher for 

large pests. 

4)  Do not place the Guardian™ directly in standing water. 

5)  Ensure there are no solid objects directly in front of The 

Guardian™ that might block the ultrasonic sound.

6)  Monitor pest activity over the next week. Adjust the control panel 

settings as necessary. Allow up to 2 to 3 weeks for best results.

Sound coverage: 6,000+ sq. ft.

(Sound does not travel through solid barriers.)

Infrared motion sensor range: Up to 100ft.

Dimensions: 6.7”H x 5.4”W x 3.1” D

Power Source: AC adapter (5ft., not included)

6X C batteries (not included)

Audio output: +95db

Power consumption: 1.8W