Ingenico IWL2XXBCL Manual De Usuario
iWL2xx Wireless Series
•
17/32
Copyright © 2011 Ingen ico
900003061 R11 000 04/1050
All rights reserved
4.5.4.
Changing the battery
It is imperative to use a battery authorized by Ingenico.
There is danger of explosion if battery used is not approved by Ingenico.
There is danger of explosion if battery used is not approved by Ingenico.
•
Remove the terminal from its base
•
Turn it off by pressing simultaneously
and
(yellow key) for
about one second
•
Remove the battery trapdoor (see section 4.5.2“installing battery”)
•
Lift the battery and remove it from its compartment
•
Carefully disconnect battery, following the
instructions below.
a) Unlock the connector by pressing the locking
mechanism as indicated by F1 arrow while pulling
wires (F2 arrow ), to disconnect the connector.
Release traction on it as soon as the connector
comes unclipped
instructions below.
a) Unlock the connector by pressing the locking
mechanism as indicated by F1 arrow while pulling
wires (F2 arrow ), to disconnect the connector.
Release traction on it as soon as the connector
comes unclipped
b) Finish extracting connector by tilting it slightly
(F3 arrow) to bring it away from the terminal
housing
(F3 arrow) to bring it away from the terminal
housing
•
Connect and install the new battery by following the instructions in section 4.5.2
“Installing battery”
“Installing battery”
•
Close the battery trapdoor and charge the new battery. See section "0 “Charging
the Battery"
the Battery"
•
In order to preserve the environnement, dispose used battery in compliance with
current country recycling legislation.
current country recycling legislation.
•
If the terminal is stored for a long time remove the battery from the terminal.
iWL2xx Wireless Series
•
18/32
Copyright © 2011 Ingen ico
900003061 R11 000 04/1050
All rights reserved
5.
Base
IXL2xx Base is available in different models. Please select by yourself in this documentation
items related to your model.
WARNING
items related to your model.
WARNING
Turn off base power supply unit before connection operation.
5.1.1.
Base rear connections
WARNING
Select an electrical socket that complies with the general safety instruction given in section
6 “Recommendations” of this document.
Follow the below instructions :
•
Connect the power supply unit after all other connections.
•
Connect the power supply unit to the base socket B.
•
Connect the power supply unit to the mains network .
A = Ethernet socket (optional)
B= power supply unit socket
C = Path for wires.
D= USB Slave socket-CDC serial mode only (optional)
E = USB host Socket 1 (optional)
F = USB host Socket 2 (optional)
A
B
C
E
D
F