HPI JAPAN INC. HPIRACING00001 Manual De Usuario
★
USAGE PRECAUTIONS
・Don't use it except a genuine product.
・A unstring and a modify are prohibition.
・From a body, please detach a transmitter 20cm or more and hold it.
・NEVER grip the antenna when using as this degrades RF quality and cause loss of control.
・Never don't cut a receiver antenna wire.
・The wave of 2.4G is intercepted with a metal or carbon.
・Please be sure to separate the antenna (leading end) of a receiver from a metal or carbon.
●The step of a binding
The transmitter has individual ID. When using a new receiver,
You make this ID register into a receiver.
This operation should work at a location without
other 2.4G waves. Please put a transmitter and a receiver on less than 1m.
1:Turn ON a transmitter, continuing pushing a setup button.
Next, detach a setup button.
2:LED of a transmitter will blink.
3:Turn on a receiver, continuing pushing the setup button of a receiver.
Next, detach a setup button.
4:If a receiver carries out an insertion success of ID of a transmitter,
you can operate a servo with a transmitter.
5:Please do not run a car then.
When you use it, once you turn OFF power Sw of a transmitter and a receiver,
Please turn ON.
●The set way of a fail-safe system(only RF-30)
If the wave of a transmitter is normally unreceivable, the file safe will operate,
And the servo operates in the position set up beforehand.
Please perform, when you change this servo place.
1:You maintenance fixing in the position which wishes the wheel and trigger of a transmitter
after No. 4 of "The step of a binding" section.
2:And please continue pushing the setup button of a receiver for several seconds.
3:Then, a few carries out a time lighting and LED completes a file safe insertion.