Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Checkpoint Systems Inc.
  4. NANOGATERF
  5. Manual De Usuario

Checkpoint Systems Inc. NANOGATERF Manual De Usuario

Descargar
Página de 2
www.alphaworld.com
Instructions for the 
Nano Gate 
NANOGATERF
MOUNTING INSTRUCTIONS:
Plug-n-Play Powered Installation
PC0277
1.  Measure the distance from wall power outlet to where the Nano Gate will be installed.
2.  Insert 6, D-size batteries into the Nano Gate (reference battery orientation in plastic housing).
3.  Place the provided Mounting Template onto a flat surface with tape.  The Mounting Template will be marked with 
TOP and BOTTOM for accurate placement and provides where the holes need to be drilled. 
NOTE: Must mount Nano Gate at least 3 feet (0.91 m) from floor
4.  Drill 6 holes as indicated on the template. 
(Fig. 1)
5.  Remove the template.  You should have 3 holes on top and 3 holes on bottom.
6.  Screw bottom bracket in place with 3 screws. 
(Fig. 2)
7.  Of the three pre-drilled holes on the top, screw the lower screw into the surface using the “U” on the bracket as 
a guide for spacing.  Do not tighten the screw down.
 (Fig. 3)
8.  Insert the bottom end into the bottom Bracket and drop the Gate into place. 
(Fig. 4)
9.  Place the Gate into pre-drilled screw on top and finish by screwing in the 2 remaining screws into the top 
bracket. 
(Fig. 5)
10. Insert the Power Supply Cord in either the top or bottom plugs. 
(Fig. 6)  Plug into an electrical outlet.  The 
Nano Gate will beep twice to indicate power.
11. Place the Caps on both top and bottom ends of the Nano Gate and screw in with the 2 provided screws. 
(Fig. 7)
12. Nano Gate is now secure and ready for use. 
(Fig. 8)
NOTE: 6’ (1.83 m) coverage requires mounting Nano Gate in off-set locations on the door.  (See Diagram 1)
PAGE 2
Figure 1 - Drill holes as 
indicated on template
Figure 2 - Screw in bottom 
Bracket
Figure 3 - Screw in top screw 
only - allowing space for the 
Bracket to slide on
Figure 4 - Insert bottom end of 
Nano Gate into bottom Bracket
Figure 5 - Screw in top 
Bracket 
Figure 6 - Insert power 
supply cord as applicable
Figure 7 - Screw in both top 
and bottom Caps
Figure 8