Zhongshan City Richsound Electronic Industrial Ltd. TB235CWW Manual De Usuario

7

You can extend the height of the unit.
Note: 
Ensure the surface is clean prior to sticking the rubber foot to the bottom of the unit. 
1.  Turn the unit upside down.
2.  Remove the backing paper from the rubber foot.
3.  Stick the rubber foot to the bottom of the unit as shown in the illustration below.

Note:
•  Installation must be carried out by qualified personnel only. Incorrect assembly can result in 

severe personal injury and property 
damage (if you intend to install this 
product yourself, you must check for 
installations such as electrical wiring 
and plumbing that may be buried 
inside the wall). It is the installer’s 
responsibility to verify that the wall will 
safely support the total load of the unit 
and wall brackets.

•   Additional tools (not included) are 

required for the installation.

•   Do not overtighten screws.
•   Keep this instruction manual for future 

reference.

•   Use an electronic stud finder to check 

the wall type before drilling and 
mounting.

1.  Drill 4 parallel holes (Ø 3-8 mm each 

according to wall type) in the wall. The 
distance between the holes should be 
764 mm.

-  Firmly fi x 1 dowel into each hole in the 

wall if necessary.

2.  Tighten the wall mount brackets on 

the wall with screws and screwdriver 
(not included). Make sure the they are 
securely installed.

3.  Loosen the screws at the back of the 

unit for 3 mm. Lift the unit onto the wall 
mount brackets and slot into place.

SOURCE

VOL

VOL