Senstech Sdn. Bhd. MD-H01 Manual De Usuario
5／17
5 Connections
The first step is to connect the components. Connect antenna board to the RFID reader / writer board using the
connector. Terminal and reader/writer can be connected by USB or UART serial port.
Pin assignment for UART serial is stated in the table below. Please prepare a harness cable for the connection to
device terminal.
connector. Terminal and reader/writer can be connected by USB or UART serial port.
Pin assignment for UART serial is stated in the table below. Please prepare a harness cable for the connection to
device terminal.
No.
Signal name
I/O
Content
1
VCC
-
Provide DC 5V (+/-0.25V)
2
GND
-
GND
3
TXD
OUT
UART serial signal output (LV-TTL)
4
RXD
IN
UART serial signal input (LV-TTL)
[Pin assignment]
6 Function and use
The equipment is ready to be operated once all connections are completed.
Next, equipment operating with SDK package will be explained. SDK Package is prepared for application
development of MMRW series. SDK Package contains demo software, USB driver, USB communication library,
and sample source code. For further details, please refer to “Demo Software Manual” before using MMRW
demo software.
Please refer to “MMRW Command Library Function Specification” to develop application.
Next, equipment operating with SDK package will be explained. SDK Package is prepared for application
development of MMRW series. SDK Package contains demo software, USB driver, USB communication library,
and sample source code. For further details, please refer to “Demo Software Manual” before using MMRW
demo software.
Please refer to “MMRW Command Library Function Specification” to develop application.