Export Management System Inc EZCODER300 Manual De Usuario
EZ Code-R300 Transmitter
OPERATING INSTRUCTIONS:
Code Setting
Code Setting
1.
You may set your transmitter to any code you desire but be sure that
the code you set matches the code that has been set on your radio
receiver. The digital code is determined by the positions of the 10 small
switches numbered 1 through 10 located in the receiver and transmitter.
receiver. The digital code is determined by the positions of the 10 small
switches numbered 1 through 10 located in the receiver and transmitter.
2.
Insert a small coin into the located at the bottom and the transmitter.
Twist the coin and remove the access cover to expose the code switch
and battery compartment. (See Diagram #1)
and battery compartment. (See Diagram #1)
DIAGRAM #1
1.
Using a sharp object or tool, such as a paper clip, set the new transmitter
code by setting the “ON” and “OFF” switches according to the exact code
setting of your previous transmitter or the receiver. (Note: The switches are in
the “ON” positions when the switch is pushed toward the letter “ON”.)
(See Diagram #2)
setting of your previous transmitter or the receiver. (Note: The switches are in
the “ON” positions when the switch is pushed toward the letter “ON”.)
(See Diagram #2)
Transmitter with
battery cover
removed
battery cover
removed
Battery cover