Rohrback Cosasco Systems ER200 Manual De Usuario
101
Bluetooth Suite
ER-100, LPR-100, ER-200, and LPR-200 Firmware Update Instructions
These instructions describe the proper procedure for updating the firmware for the ER-100, LPR-
100, ER-200, and LPR-200.
Required Equipment:
•
Device to be updated
•
Kinivo Bluetooth USB
•
Cosasco Bluetooth USB (P/N 726033)
•
PC with USB port
WARNING:
This operation is intended to be done in a Non-Hazardous Area.
This process can take approximately 20 minutes to complete.
A close proximity of 3 feet or less is recommended between the Device and the PC.
DO NOT REMOVE BATTERIES UNTIL FIRMWARE UPDATE IS COMPLETED.
1. If not installed, install the drivers for the Kinivo USB device. The drivers are included on
the Cosasco Bluetooth USB.
2. If not installed, install the Device Firmware Update Software. The software is included on
the Cosasco Bluetooth USB device within the Cosasco Data Installation.
3. Plug in the Kinivo Bluetooth USB device into the PC USB Port. Utilize the USB Ports on
the back of a Desktop PC where possible to help avoid errors.
4. Open the Device Firmware Update Software. This can typically be found in:
Start All Programs Cosasco Cosasco Data Devices Device Firmware Update