Qiaoxing Telecom Industry Co. Ltd. GH9460-GH9620 Manual De Usuario

Changing the BATTERY PACK

The BATTERY PACK provides power for the HANDSET of your cordless telephone.

To Replace BATTERY PACK:

1. Remove

the

HANDSET BATTERY COMPARTMENT COVER by sliding it down.

2. Pull out the BATTERY PACK PLUG and remove the BATTERY PACK.
3. Plug the new BATTERY PACK into the BATTERY CONNECTOR.
4. Slide

the

HANDSET BATTERY COMPARTMENT COVER firmly into place in its closed position.

5. Before use, charge the new BATTERY PACK for 12 hours.

ATTENTION

The telephone that you have purchased contains a rechargeable BATTERY PACK. The BATTERY
PACK is recyclable. At the end of its useful life, under various state and local laws, it may be illegal to
dispose of this BATTERY PACK into the municipal waste stream. Check with your local solid waste
officials for details in your area for proper disposal.

Remove the HANDSET battery
compartment cover by sliding it down

IMPORTANT

In order to get maximum life from the HANDSET

BATTERY PACK, be sure to charge the HANDSET for 12

hours before initial use.

Problem Solving

Problem Solving Section

For your assistance, we have listed below a few common problems.

Phone does not work, check the following:

1. BASE UNIT is plugged into a power source.
2. HANDSET is charged.
3. TELEPHONE LINE CORD is plugged into the TELEPHONE JACK.

Range of phone limited, check the following:

1. BASE UNIT is centrally located in your residence.
2. BASE UNIT is not located near appliances.

No dial tone, check the following:

1. TELEPHONE LINE CORD plugs are connected to the TELEPHONE JACK and TELEPHONE

LINE CONNECTION JACK.

2. BASE UNIT is plugged into power source.,
3. If you had a power failure of had unplugged the BASE UNIT, replace the HANDSET on the

BASE UNIT for 2 to 5 seconds to reset the system.

Received signal flutters or fades, check the following:

1. BATTERY PACK in the HANDSET is fully charged.
2. HANDSET is not too far from the BASE UNIT.

Interference on reception, check the following:

1. Noise may be picked up from electrical products in the home or electrical storms. Generally,

this noise is a minor annoyance and should not be interpreted as a defect in your system.

2. Choose an alternate channel using the

Button on the HANDSET.

3. Do not use this telephone within 20ft. Of a microwave oven while it is working. As you may

experience interference. This is a normal occurrence with 2.4 GHZ phones and should not be
interpreted as a defect in the product.

Long Distance “L-D-C” indicator is not ON when receiving a long distance call,
check the following:

1. Your local telephone company can provide the Area Code on an incoming long distance call.

Excess static, check the following:

1. Check to see that the ANTENNA is not touching another metal object.

If after pressing the

button, you receive three “beeps” and no dial tone,

check the following:

1. BASE UNIT is plugged into a power source.
2. If you had a power failure of had unplugged the BASE UNIT, replace the HANDSET on the

BASE UNIT for 2 to 5 seconds to reset the system.

talk

scan

delete

BATTERY PACK PLUG

BATTERY PCAK

BATTERY

COMPARTMENT

COVER

BATTERY
CONNECTOR