Giant Telecom Limited CP300A Manual De Usuario
7
4
Plug the power cord into the corresponding jack on the bottom of the handset or place the
handset in the charging cradle properly.
handset in the charging cradle properly.
5
Connect the power supply to a live outlet.
6
Leave the Handset for 15 hours so that the battery pack is fully charged.
7
The battery icon will flash during charging. While the battery is fully charged, it stops
flashing.
flashing.
4. BASIC OPERATION
4.1 Switch the Phone On/Off
Press and hold the [END] key for 2 seconds to turn the Phone on or off. The phone will display
the power on / off graphic.
the power on / off graphic.
4.2 Setting Up the Phone (Run Easy Setup)
NOTE:
Before you begin, make sure you have an active Internet connection and the account
information provided by your Internet phone service provider.
1. Press and hold the [Power key] for 2 seconds to turn on the Phone.
2. Press [Left-Soft-key] to enter MENU.
3. Scroll to Admin Conf, and then press the [Left-Soft-key] to enter.
4. Input
2. Press [Left-Soft-key] to enter MENU.
3. Scroll to Admin Conf, and then press the [Left-Soft-key] to enter.
4. Input
the
Admin Password.
Default Admin Password is 1111. You can press [*] key to
change the input method.
5. When you are finished entering a password, press [Left-Soft-key] to confirm.
6. Scroll to Others, then press [Left-Soft-key] to enter.
7. Scroll to Easy Setup, then press [Left-Soft-key] to enter.
8. Select your desired SSID or input the SSID name manually, then press [Left-Soft-key]
6. Scroll to Others, then press [Left-Soft-key] to enter.
7. Scroll to Easy Setup, then press [Left-Soft-key] to enter.
8. Select your desired SSID or input the SSID name manually, then press [Left-Soft-key]
to confirm.
9. Select the Encryption Mode (None, WEP or WPA Personal)
10. Select WEP Bits (64 or 128). If you select None or WPA in step 9, just press
10. Select WEP Bits (64 or 128). If you select None or WPA in step 9, just press
[Left-Soft-key] to jump to next step.
11. Input the WEP Key. If you select None or WPA in step 9, just press [Left-Soft-key] to
jump to next step.
12. Input the Passphrase of WPA. If you select None or WEP in step 9, just press
[Left-Soft-key] to jump to next step.
13. Input the Username of your Internet phone service provider’s account.
14. Input the Password of your Internet phone service provider’s account.
15. Input your Display Name of your Internet phone service provider’s account.
16. Input the Domain of your Internet phone service provider’s account.
17. Input the Registrar of your Internet phone service provider’s account.
14. Input the Password of your Internet phone service provider’s account.
15. Input your Display Name of your Internet phone service provider’s account.
16. Input the Domain of your Internet phone service provider’s account.
17. Input the Registrar of your Internet phone service provider’s account.