Alpha Networks Inc. C300RI Manual De Usuario

Descargar
Página de 97
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Federal Communication Commission Interference Statement 
This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection 
against harmful interference in a residential installation.  This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications.  However, there is no guarantee that 
interference will not occur in a particular installation.  If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one of the following measures: 
 
Reorient or relocate the receiving antenna. 
Increase the separation between the equipment and receiver. 
Connect the equipment into an outlet on a circuit different from that 
to which the receiver is connected. 
Consult the dealer or an experienced radio/TV technician for help. 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept 
any interference received, including interference that may cause undesired operation. 
 
FCC Caution: Any changes or modifications not expressly approved by the party responsible for 
compliance could void the user's authority to operate this equipment. 
 
IMPORTANT NOTE: 
FCC Radiation Exposure Statement: 
This equipment complies with FCC radiation exposure limits set forth for an 
uncontrolled environment. This equipment should be installed and operated with 
minimum distance 20cm between the radiator & your body. 
This transmitter must not be co-located or operating in conjunction with any other 
antenna or transmitter. 
 
 
The availability of some specific channel(s) and/or function(s) are country 
dependent and are firmware programmed at the factory to match the intended 
destination. The firmware setting is not accessible to the end user. 
For US models; IEEE 802.11b/g and 11n (20M) operation are firmware-limited to 
channels 1-11 and 11n (40M) from channels 1-7.