Alpha Networks Inc. SPADPT08 Manual De Usuario
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules and RSS-210 of the Industry Canada Rules. Operation
is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment
IEEE802.11b ,IEEE802.11g and IEEE802.11n HT20 operation mode of this device in the U.S.A is firm
ware-limited to channels 1 though 11, and channels 3 though 9 for IEEE802.11n HT40 mode.
This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment has been
SAR-evaluated for use in hand. SAR measurements are based on a 0.5cm spacing from the body and that
compliance is achieved at that distance.
SAR compliance has been established in typical laptop computer(s) with USB slot, and product could be used in
typical laptop computer with USB slot. Other application like handheld PC or similar device has not been verified
and may not compliance with related RF exposure rule and such use shall be prohibited.