C-Com Corporation 56AZBT Manual De Usuario
5.5 AT+MS Command
+MS
Modulation select
This command selects the modulation, optionally enables/disables Automode, and optionally
specifies the lowest and highest connection rates.
The command format is:
AT+MS= [<mod>][,[<automode>][,[<min_rate>][,[<max_rate>]]]]
<mod> a decimal number specifying the preferred modulation (automode enabled), or the
modulation (automode disabled).
<automode> 0/1 Automode disabled/enabled
<min_rate> minimum rate for connection. If lower than the actual minimum rate for the selected
modulation, the actual lowest supported rate will be taken.
<max_rate> maximum rate for connection. If higher than the actual maximum rate for the selected
modulation, the actual highest supported rate will be taken.
Table 2 - +MS command parameters
<mod> Modulation Possible rates
22 V.22 1200
122 V.22bis 2400,1200
32 V.32 9600, 4800
132 V.32bis 14400, 12000, 9600, 7200, 4800
34 V.34 33600, 31200, 28800, 26400, 24000,
21600, 19200,16800, 14400, 12000,
9600
56 K56Flex 32000,34000,36000 ..... ,56000
90 V.90 29333, 30666,32000 .....,56000
212 Bell 212 1200
103 Bell 103 300