DLP Design Inc. 000RF2 Manual De Usuario
Rev 1.0 (January 2005)
DLP-RF2
DLP Design, Inc.
11
End Product Labeling
The final end product must be labeled in a visible area with the following: “Contains TX FCC ID:
SX9000R
SX9000R
F2”.
RF Exposure Statements That May be Included in the Users Manual
The users manual for end users must include the following information in a prominent location
“IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna
used for this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.”
“IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna
used for this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.”
Additional Information That Must be Provided to OEM Integrators
The end user should NOT be provided any instructions on how to remove or install the device.
8.0 Disclaimer
Neither the whole nor any part of the information contained herein nor the product described in
this datasheet may be adapted or reproduced in any material or electronic form without the prior
written consent of the copyright holder.
This product and its documentation are supplied on an as-is basis, and no warranty as to their
suitability for any particular purpose is either made or implied. DLP Design will not accept any
claim for damages whatsoever arising as a result of use or failure of this product. Your statutory
rights are not affected.
This product or any variant of it is not intended for use in any medical appliance, device, or
system in which the failure of the product might reasonably be expected to result in personal
injury.
This document provides preliminary information that may be subject to change without notice.
this datasheet may be adapted or reproduced in any material or electronic form without the prior
written consent of the copyright holder.
This product and its documentation are supplied on an as-is basis, and no warranty as to their
suitability for any particular purpose is either made or implied. DLP Design will not accept any
claim for damages whatsoever arising as a result of use or failure of this product. Your statutory
rights are not affected.
This product or any variant of it is not intended for use in any medical appliance, device, or
system in which the failure of the product might reasonably be expected to result in personal
injury.
This document provides preliminary information that may be subject to change without notice.
9.0 Contact Information
DLP Design, Inc.
1605 Roma Lane
Allen, TX 75013
Phone: 469-964-8027
Fax:
1605 Roma Lane
Allen, TX 75013
Phone: 469-964-8027
Fax:
415-901-4859
Email: support@dlpdesign.com
Internet: http://www.dlpdesign.com