DLP Design Inc. RFS2 Manual De Usuario
Rev 1.1 (September 2017) 6
DLP Design, Inc.
6.4.2
Press and hold button 3. While holding button 3 press and release RESET.
Continue to hold button 3 until you hear the beep. Release button 3 and the system will be
transmitting at 2.4GHz on the internal chip antenna with GFSK modulation.
transmitting at 2.4GHz on the internal chip antenna with GFSK modulation.
6.5
For range test mode with two paired transceivers where transceiver A makes transceiver
B beep with each packet sent.
6.5.1
Press Button 1 until LORA mode is selected on both transceivers:
6.5.2
Pair the transceivers: on transceiver 1, Press and hold button 4. While holding
button 4 press and release RESET. Continue to hold button 4 until you hear a beep.
Release button 4 and the transceiver will be waiting for the ID from transceiver 2 and "wait"
will be shown in the display.
Release button 4 and the transceiver will be waiting for the ID from transceiver 2 and "wait"
will be shown in the display.
6.5.3
On transceiver 2, press and release RESET. Every time a transceiver is
RESET it will transmit its ID immediately after reset on a specific RF frequency using specific
modulation parameters. The display on transceiver 1 will then show the ID for transceiver 2.
modulation parameters. The display on transceiver 1 will then show the ID for transceiver 2.
6.5.4
On transceiver 2, Press and hold button 4. While holding button 4 press and
release RESET. Continue to hold button 4 until you hear a beep. Release button 4 and the
transceiver will be waiting for the ID from transceiver 1 and "wait" will be shown in the display.
transceiver will be waiting for the ID from transceiver 1 and "wait" will be shown in the display.
6.5.5
On transceiver 1, press and release RESET. The display on transceiver 2 will
then show the ID for transceiver 1. At this point the transceivers are paired. Additional
RESETs or power cycles will not change the pairing.
RESETs or power cycles will not change the pairing.
6.5.6
Enter Range Test: Press Button 1 until LORA mode is selected on both
transceivers:
6.5.7
On transceiver 1, press and hold button 5. While holding button 5 press and
release RESET. Continue to hold button 5 until you hear a beep then release button 5.
Press and release RESET on transceiver 2. At this point transceiver 1 will be transmitting
Press and release RESET on transceiver 2. At this point transceiver 1 will be transmitting