Bellwave Co. Ltd. X100SA Manual De Usuario

Before a phone model is available for sale to the

public, it must be tested and certified to the FCC

that it does not exceed the limit established by

the government-adopted requirement for safe

exposure. The tests are performed in positions

and locations (e.g., at the ear and worn on the

body) as required by the FCC for each model.

(Body-worn measurements differ among phone

models, depending upon available accessories

and FCC requirements). While there may be

differences between the SAR levels of various

phones and at various positions, they all meet

the government requirement.

For body worn operation, this phone has been

tested and meets FCC RF exposure guidelines

when used with an accessory that contains no

metal and that positions the handset a minimum

of 15 mm from the body. Use of other

accessories may not ensure compliance with FCC

RF exposure guidelines.

For additional information concerning exposure to

radio frequency signals, see the following

websites:

Federal Communications Commission (FCC)

RF Safety program (select “Information on

Human Exposure to RF Fields from Cellular and

PCS Radio Transmitters”):

http://www.fcc.gov/oet/rfsafety

World Health Organization (WHO)

International Commission on Non-Ionizing

Radiation Protection (select Qs & As):

http://www.who.int/emf

Your mobile phone is a radio transmitter and

receiver. It is designed and manufactured not to

exceed the emission limits for exposure to radio

frequency (RF) energy set by the Federal

Communications Commission of the U.S.

Government. These limits are part of

comprehensive guidelines and establish permitted

levels of RF energy for the general population.

Those guidelines are consistent with the safety

standard previously set by both U.S. and

international standards bodies:

• American National Standards Institute (ANSI)

IEEE. C95.1-1992

• National Council on Radiation Protection and

Measurement (NCRP). Report 86

• International Commission on Non-Ionizing

Radiation Protection (ICNIRP) 1996

• Ministry of Health (Canada), Safety Code 6.

The exposure standard for wireless mobile

phones employs a unit of measurement known as

the Specific Absorption Rate, or SAR. The SAR

limit set by the FCC is 1.6W/kg. 

Tests for SAR are conducted using standard

operating positions specified by the FCC with the

phone transmitting at its highest certified power

level in all tested frequency bands. Although the

SAR is determined at the highest certified power

level, the actual SAR level of the phone while

operation can be well below the maximum value.

This is because the phone is designed to operate

at multiple power levels so as to use only the

power required to reach the network. In general,

the closer you are to a wireless base station

antenna, the lower the power output.