BMI Technologies Inc. RFVI Manual De Usuario
DRAFT G FORCE PLUS RF Instruction Manual
Doc #RF1 Rev.9
51
Apr/08
3. A new Operator must restart the Vehicle in order to have his/her Operator Card validated in the Operator
Login state.
IMPACT
1. If a threshold-exceeding Impact is detected, the Vehicle enters Impact state.
a. The Vehicle Interface buzzer will sound (1 second every 2 seconds), or
b. The Vehicle Interface buzzer and horn will sound as programmed under System Settings, and
c. Programmed Impact behavior (i.e. lift interrupt, etc.) will exhibit, and
d. The Vehicle Interface will display “(TYPE) IMPACT! CONTACT SUPERVSR”, where (TYPE) is
SOFT or HARD.
2. Present a valid Supervisor Card to the Vehicle Interface and hold it until the Vehicle Interface beeps
solidly.
3. Remove the Card from the Vehicle Interface. It will display “OPERATOR LOGIN PRESENT
CARD”.
4. A Vehicle keyed off in Impact state will revert to Impact state when it is keyed on.
HOT CARD
1. If a Hot Card is detected during the Operator Login, the Vehicle enters Hot Card state.
a. The Vehicle Interface buzzer will sound, or
b. The Vehicle Interface buzzer and horn will sound as programmed under System Settings, and
c. Programmed Hot Card behavior (i.e. lift interrupt, etc.) will exhibit, and
d. The Vehicle Interface will display “HOT CARD! CONTACT SUPERVSR”.
2. Present a valid Supervisor Card to the Vehicle Interface and hold it until the Vehicle Interface stops
sounding.
3. Remove the Card from the Vehicle Interface. It will display “OPERATOR LOGIN PRESENT
CARD”.
4. A Vehicle keyed off in Hot Card state will revert to Hot Card state when it is keyed on.