BMI Technologies Inc. VUI00 Manual De Usuario
DRAFT G FORCE PLUS & G FORCE PLUS RF Instruction Manual
Doc #RF1 Rev.2
7
Nov 2005
1. Hold the Card parallel to the top of the Software Interface, making sure they are within 1” of each other
(or lay the Card on the Software Interface).
INSERT PHOTO
2. Initiate the interaction between the Software Interface and Card by selecting the desired task from the
Fleet Manager software.
3. Watch the software for progress of the interaction.
4. Confirm completion of the interaction when prompted by the software.
4. Confirm completion of the interaction when prompted by the software.
5. Remove the Card from the Software Interface.
6. If the interaction fails, remove the Card from the Software Interface by approximately 12” and retry.
Software Interface and Data Logger
1. Prepare the Data Logger for the interaction by selecting the desired Data Logger function.
2. Hold the Data Logger parallel to the top of the Software Interface, making sure they are within 1” of each
2. Hold the Data Logger parallel to the top of the Software Interface, making sure they are within 1” of each
other (or lay the Data Logger on the Software Interface).
INSERT PHOTO
3. Initiate the interaction between the Software Interface and Data Logger by selecting the desired task from
the Fleet Manager software.
4. Watch the software for progress of the interaction.
5. Confirm completion of the interaction when prompted by the software.
INSERT SCREEN SHOT
6. Remove the Data Logger from the Software Interface.
7. If the interaction fails, remove the Data Logger from the Software Interface by approximately 12” and
5. Confirm completion of the interaction when prompted by the software.
INSERT SCREEN SHOT
6. Remove the Data Logger from the Software Interface.
7. If the interaction fails, remove the Data Logger from the Software Interface by approximately 12” and
retry.
QUICK-START
This Quick-Start section summarizes the system setup steps without providing detailed how-to
instructions. Complete them in the order shown. Detailed instructions follow beginning with the
INSTALLATION INSTRUCTIONS
. Settings are defined in the section
DATA FIELDS EXPLAINED
.
1. Install the Vehicle Monitors and Interfaces.
2. Install the Fleet Manager software and Interface.
3. Install the RF Transceivers (G FORCE PLUS RF system only).
4. Set up the Fleet Manager software.
a. Define settings that apply to all Vehicles (Setup | System Settings on the menu).
b. Define (up to 64) Authorization Groups and group settings (Authorization Groups tab).
b. Define (up to 64) Authorization Groups and group settings (Authorization Groups tab).
i. Add Authorization Groups and settings (Add button).
ii. Select Vehicle Inspection checklist (Inspection List lower tab).
ii. Select Vehicle Inspection checklist (Inspection List lower tab).